Nickel Single Hilt Square, Red and Aluminum Spacers, Nickel Butt Cap, Wrist Thong, Thumb Notches, Finger Grips, Each Engraved "September 2012" on reverse.
Top is Nordic Supplied Ironwood. Bottom is Shop Supplied Black Micarta
is your 70's NDP a 3 1/4" or 4" blade. I have one with the same spacers but mine is a 4" blade.
knife is shown on first page of this thread.
Attachments
------
------
Edited by maxpastor (06/24/1512:58 PM)
_________________________
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
this is where it get interesting. the sheath is marked 11 45
I am not sure the sheath is original. the knife is .241 thick almost 1/4" maybe the knife was a 4 1/2" and was cut down removing the notch???? if so it appears to have been a good job. would the Randall shop have done something like that?? I thought it was a NDP with a mis-matched sheath. but now I think it is a ground down Model 11, here is the back of the sheath.
Attachments
------
_________________________
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."