Stanback Knives Clinton Knives
The RANDALL KNIFE FORUMS

A place where EVERYBODY is welcome to join in on the discussion of Randall Made knives


Page 27 of 39 < 1 2 ... 25 26 27 28 29 ... 38 39 >
Topic Options
Rate This Topic
#133056 - 10/31/15 09:36 PM Re: Knife of the Week Model 3 !!! * [Re: Captain Chris Stanaback]
Michael_Mason Offline
Knife Enthusiast

Registered: 02/12/06
Posts: 1937
Loc: Orlando, FL.
Isn't that the configuration that a 'Recon' is based on ?
Less the etching of course !!
_________________________
Michael

Top
#135929 - 01/16/16 08:37 AM Re: Knife of the Week Model 3 !!! [Re: RKS3500]
Hayst Offline
Knife Enthusiast

Registered: 12/03/15
Posts: 26
Late 60's era 3-6 wearing an early 60's Heiser sheath listed elsewhere in these fora, included here as a courtesy to those who wish to reference Randall model 3's.





Top
#135941 - 01/16/16 03:45 PM Re: Knife of the Week Model 3 !!! [Re: Hayst]
Tattoo Bill Offline
Knife Enthusiast

Registered: 07/14/15
Posts: 1907
Loc: Spring Hill, Florida
That sheath!!!
_________________________
Tattoo Bill
Spring Hill, FL.
Livin On The Edge!
ta2bill@yahoo.com


Top
#135952 - 01/16/16 08:20 PM Re: Knife of the Week Model 3 !!! [Re: Hayst]
crutchtip Offline
Knife Enthusiast

Registered: 11/16/05
Posts: 2851
can you post some better photos of the knife so we can see the blade and the rear of the sheath? What stone is in the pouch?
_________________________
www.rmkcollector.com

BUY-SELL-TRADE

Top
#135960 - 01/17/16 03:09 AM Re: Knife of the Week Model 3 !!! [Re: crutchtip]
Hayst Offline
Knife Enthusiast

Registered: 12/03/15
Posts: 26





Whether by design or happenstance the knife exhibits a balance that is perfect, namely directly beneath the two rearmost spacers...held blade down or on either side.

The knife simply feels light and easy to handle and as such is my using knife.



The stone came with the sheath and has not been touched by a blade, pretty much pristine as was the sheath, of interest is the sheath had been soaked in an oil when produced and when I soaked the sheath in warm water to fit the knife it dried whilst still holding the oil and shape.
And the smell is one I have not smelt on leather since I was a lad, as the current leather produced simply does not smell the same.

Top
#135961 - 01/17/16 03:23 AM Re: Knife of the Week Model 3 !!! [Re: Hayst]
Ronnie Offline
Knife Enthusiast

Registered: 02/13/11
Posts: 2270
Loc: NW Mississippi
Do you think that sheath may be a bit earlier than the early 60's?
Just asking.
Btw that is a beautiful rig. Great knife and great sheath.


Edited by Ronnie (01/17/16 03:23 AM)
_________________________
Ronnie
RKS#2166

Top
#135962 - 01/17/16 03:39 AM Re: Knife of the Week Model 3 !!! [Re: Ronnie]
Hayst Offline
Knife Enthusiast

Registered: 12/03/15
Posts: 26


I do not think so Ron, I tend toward 61-62 at the last of the Heiser run.

The knife and sheath seem to be made for each other, a much nicer fit than the current Sullivans.

Just luck of the draw.

Top
#135963 - 01/17/16 04:34 AM Re: Knife of the Week Model 3 !!! [Re: Hayst]
Ronnie Offline
Knife Enthusiast

Registered: 02/13/11
Posts: 2270
Loc: NW Mississippi
Well they are both beauties. You did good.
Thanks.
_________________________
Ronnie
RKS#2166

Top
#135964 - 01/17/16 08:13 AM Re: Knife of the Week Model 3 !!! [Re: Ronnie]
BoBlade Offline
Knife Enthusiast

Registered: 09/13/05
Posts: 1673
Loc: Kalifornia
Hayst,

FYI here is a 3-6 that was made the same time as your sheath (Very early 60's). Note the big difference in choil cuts vs your late 60's knife:



Here are a few more sheaths with those same snaps:



One of the above sheaths has the Heiser mark. The other is not marked at all:









Here is that same snap on a Heiser cartridge carrier:





It was pretty close to a decade after the first brown button outage in the very early 50's that it happened a second time.

Ron
_________________________
Ron Mathews
RKS No. 4223


Top
#135967 - 01/17/16 09:07 AM Re: Knife of the Week Model 3 !!! [Re: BoBlade]
Hayst Offline
Knife Enthusiast

Registered: 12/03/15
Posts: 26


Yes, I figured the centre awl hole combined with the plain steel button cemented the 61-62 dating.

Next I will look for a stag 7-4 with a Heiser sheath, not a pinned one though.

Top
Page 27 of 39 < 1 2 ... 25 26 27 28 29 ... 38 39 >


Moderator:  Mr_Mod